The range between the speaker and the receiver is measured in open air.Do not subject the speaker to wet, moist or excessively dusty environments, as this may cause damage.Do not leave the speaker in direct sunlight or near any heat source, as it may overheat.The speaker is for indoor use only and can be used in temperatures ranging from 0º C to 40º C.Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or similar.If the supply cord is damaged, replace it with a new cord set which is type-approved for your country.The mains plug or an appliance coupler is to be used as a disconnect device, the disconnect device shall remain readily operable.Never place this product on other electrical equipment.The apparatus shall not be exposed to dripping or splashing, no objects filled with liquids, such as vases, shall be placed on the apparatus. Never place the product or batteries near open flames or other heat sources, including direct sunlight.Ensure curtains or other objects ever cover the ventilation slots on the product. Always leave a space of at least 5 mm around the product for ventilation. Risk of overheating! Never install the product in a confined space.The factory reset will clear all Bluetooth devices and sound settings, and it will activate the auto-off function. A louder confirmation sound will be played. Release the knob when the LED light turns red the fifth time (after approximately 30 seconds). Factory reset Press and hold the knob (1). ENEBY will now not turn off automatically. Release the knob when the LED light turns red the fourth time. Disable the auto-off function Press and hold the knob (1). Confirm by pressing the knob once and this also exits the sound settings. Confirm the bass setting and activate the treble setting by pressing the knob once. Release the knob when the LED light turns red the third time. Set bass and treble Press and hold the knob (1). To disable the stereo pair, follow the instructions “Unpair Bluetooth devices” on both speakers. Open the Bluetooth setting on your mobile device and connect to the ENEBY speaker for the left channel. Press the knob (1) once again on one of the speakers.This speaker is now assigned as the left channel.Ĥ. Release the knobs when the LED light turns red the second time. Wait 2 seconds. Press and hold the knobs (1) at the same time. On/Off and Volume need to be controlled individually on each speaker.Ģ. In this configuration, one speaker serves as the left channel and the other serves as the right channel. Release the knob when the LED light turns red the first time. A confirmation sound will be played. (Note that on some phone models you also need to remove ENEBY20/30 from the phone’s paired devices list to be able to pair again.) Set up a stereo pair You can pair two identical ENEBY speakers to create a wider stereo experience. Other Settings Unpair Bluetooth devices Press and hold the knob (1). Use holes (4) and included screws to mount stand or wall mount. During charging the red LED is on.ĮNEBY wall mount and ENEBY stand are accessories and are sold separately. When battery is low a red LED in the knob (1) will flash.The battery is charging in the product when mains cord is connected and the speaker is turned on.To insert the battery, open the compartment lid (5) and insert the battery in the correct direction.Use speaker throughout home:ĮNEBY 20 has the possibility to be portable. Use a 3.5mm 3-pol Audio cable for this feature. The speaker automatically detects the external input and disables Bluetooth functionality. Go to your Bluetooth menu on your mobile device and unpair ENEBY 20/30 from your devices.Ĭonnect a portable audio device to the AUDIO IN (3) jack on the rear panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |